64 HP CV Shaft with Clutch 1 3/8" 21 Splines at Both Ends Length: 75" - 114" – Part # WC61502121
106 CV Joint Shaft pto 100 HP CV Shaft with 1 3/8" 6 Splines at Tractor End with no Implement YokeLength: 60" - 85" $899.99
106 CV Joint Shaft pto 125HP CV Shaft with 1 3/8" 6 Splines at Tractor End and 1 3/8" 21 at Implement EndLength: 68" - 107" $2,259.99
Series 664HP

64 HP CV Shaft with Clutch 1 3/8″ 21 Splines at Both Ends Length: 75″ – 114″

Part No. WC61502121 · Overall length 75″ – 114″

$989.99

Cross to cross
63″ – 102″
Overall
75″ – 114″
Power rating
64 HP
at 540 rpm
Tractor yoke
1 3/8″ 21 Quick Connect

Units Sold: 1

Contact Us

Some products might be temporarily out of stock, please text the number below for stock update.

Text us @ 346-465-2689

Click here to email us

Specifications

64 HP CV Shaft with Clutch 1 3/8" 21 Splines at Both Ends Length: 75" - 114" specifications
Part numberWC61502121
Shaft seriesSeries 6
Mfg.Bare-co
Overall Length75″ – 114″
Cross to Cross63″ – 102″
Tractor Yoke1 3/8″ 21 Quick Connect
Clutch1 3/8″ 21
Clutch Dia.8"
SeriesWB6
HP100 @ 1000 RPM
Safety ShieldYes
Power rating64 HP at 540 rpm
Shipping weight106 lbs

Will it fit?

  1. Hook up the implement and set it at its shortest working position.
  2. Measure from the center of the tractor-end cross to the center of the implement-end cross.
  3. Your measurement must fall inside 63″ – 102″ for this shaft.
  4. Check your tractor's HP is at or below 64 HP at 540 rpm.
Not the right length? Use the PTO shaft selector

About this part

WARNING

80 degree (75 degree for P675 Series) Short Term Operation and Stationary.
25 degree Continuous Operation
Exceeding maximum angle will result in joint ball / socket FAILURE!
(NOT COVERED BY WARRANTY)
Tractor turning limiter should be fitted to the implement drawbar.

Related products