100 HP CV Shaft with 1 3/8" 6 Splines at Both EndsLength: 77" - 116" – Part # WB8150
100 HP CV Shaft with 1 3/8" 6 Splines at Both EndsLength: 77" - 116" – Part # WB8150 100 HP CV Shaft with 1 3/8" 6 Splines at Both EndsLength: 60" - 85" $1,144.99
100 HP CV Shaft with 1 3/8" 6 Splines at Both EndsLength: 77" - 116" – Part # WB8150 100 HP CV Shaft with 1 3/8" 6 Splines at Tractor End with no Implement YokeLength: 60" - 85" $899.99
100 HP

100 HP CV Shaft with 1 3/8″ 6 Splines at Both EndsLength: 77″ – 116″

Part No. WB8150 · Overall length 75″ – 116″

$964.99

Cross to cross
63″ – 102″
Overall
75″ – 116″
Both yokes
1 3/8″ 6 Quick Connect

Units Sold: 3

Contact Us

Some products might be temporarily out of stock, please text the number below for stock update.

Text us @ 346-465-2689

Click here to email us

Specifications

100 HP CV Shaft with 1 3/8" 6 Splines at Both EndsLength: 77" - 116" specifications
Part numberWB8150
Mfg.Bare-co
Overall Length75″ – 116″
Cross to Cross63″ – 102″
Tractor Yoke1 3/8″ 6 Quick Connect
Implement Yoke1 3/8″ 6 Quick Connect
SeriesWB8
HP160 @ 1000 RPM
Safety ShieldYes
Shipping weight106 lbs

Will it fit?

  1. Hook up the implement and set it at its shortest working position.
  2. Measure from the center of the tractor-end cross to the center of the implement-end cross.
  3. Your measurement must fall inside 63″ – 102″ for this shaft.
Not the right length? Use the PTO shaft selector

About this part

WARNING

80 degree (75 degree for P675 Series) Short Term Operation and Stationary.
25 degree Continuous Operation
Exceeding maximum angle will result in joint ball / socket FAILURE!
(NOT COVERED BY WARRANTY)
Tractor turning limiter should be fitted to the implement drawbar.

Related products